Installation Guide

13Smart-UPS On-Line SRT1000/SRT1500 Tower/Rack-Mount 2U
Key to identify rear panel features
UPS Configuration
Connect Emergency Power Off feature
For instructions on how to connect the Emergency Power Off (EPO) switch, refer to the Operation and
Maintenance manual on the User Documentation CD (supplied).
Verify input connection
UPS displays Site Wiring Fault if the line and neutral connections are interchanged or if ground connection is
missing. Correct the input connections and press
OK button to clear the Site Wiring Alert. See the Config Menu
UPS section in the UPS operation manual for details.
Configure controllable outlet groups
The outlets on the UPS are grouped. To configure the controlled outlet features, use the Advanced menus on the
display interface and navigate to: Main Menu > Configuration > Outlets > Outlet Group.
 SmartSlot The SmartSlot can be used to connect optional management accessories.
 AC input power cable or
hardwire input box
All models have factory installed input power cables.
Hardwired input box is an optional accessory.
 External battery power and
communication connector
Use the external battery cable on the XLBP to connect the UPS and XLBP.
XLBPs provide extended runtime during power outages. The UPS will
automatically recognize up to 10 external battery packs.
 Controllable
outlet group 1
Connect electronic devices to these outlets.
 Chassis ground screw The UPS and XLBPs have ground screws for connecting the ground leads. Prior to
connecting a ground lead, disconnect the UPS from mains power.
 Controllable
outlet group 2
Connect electronic devices to these outlets.
 EPO terminal The Emergency Power Off (EPO) terminal allows the user to connect the UPS to a
central EPO system.
 Serial Com The Serial Com port is used to communicate with the UPS.
Use only interface kits supplied or approved by APC by Schneider Electric.
Any other serial interface cable will be incompatible with the UPS connector.
 USB port The USB port is used to connect either a server for native operating system
communications, or for software to communicate with the UPS.