User manual

Smart-UPS Rack-Mount2U 750/1000/1500 VA 120/230 Vac, 3000 VA 100/120/208/230 Vac, 2200 VA 120 Vac 4
Operation
Connect Equipment to UPS
Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not
expect full battery runtime capability during this initial charge period.
1. Connect equipment to the outlets on the rear panel of the UPS.
2. Connect the UPS to the building utility power.
Always connect the UPS to a two pole, three wire, grounded source.
3. To use the UPS as a master O
N/OFF switch, turn on all the equipment that is connected to the UPS.
4. Press the O
N/OFF button on the front panel of the UPS to turn on the UPS and all connected equipment.
5. See “UPS Settings” on page 1 for information on how to configure the outlet groups.
CAUTION
DAMAGE TO EQUIPMENT OR PERSONNEL
• When installing equipment in a rack, always install the UPS at the bottom of the rack with the peripheral
equipment above the UPS.
• The UPS should always be installed below peripheral equipment in rack or stack configurations.
Failure to follow these instructions can result in equipment damage and minor or moderate injury
CAUTION
RISK OF EQUIPMENT DAMAGE
• Adhere to all national and local electrical codes.
• Wiring should be performed by qualified electrician.
• Always connect the UPS to a grounded outlet.
Failure to follow these instructions can result in equipment damage
su0628a