User manual
Table Of Contents
- Product Description
- Important Safety Messages
- Safety and General Information
- Front and Rear Panel Features
- Specifications
- Installation
- Operation
- Connect Equipment to UPS
- Display Panel Features
- Display Interface Menus
- Configuration
- UPS Settings
- Emergency Power Off
- Troubleshooting
- Service
- Two Year Limited Factory Warranty
15Smart-UPS Rack-Mount2U 750/1000/1500 VA 120/230 Vac, 3000 VA 100/120/208/230 Vac, 2200 VA 120 Vac
The Fault LED is illuminated
The UPS displays a fault message and emits a constant beeping sound
Internal UPS fault. Do not attempt to use the UPS. Turn the UPS off and have it serviced
immediately.
All LEDs are illuminated and the UPS is plugged into a wall outlet
The UPS has shut down and the
battery has discharged from an
extended outage.
None. The UPS will return to normal operation when the power is restored
and the battery has a sufficient charge.
The Replace Battery LED is illuminated
The battery has a weak charge.
Allow the battery to recharge for at least four hours. Then, perform a self-test.
If the problem persists after recharging, replace the battery.
The replacement battery is not
properly connected.
Be sure the battery connector is securely connected.
The UPS displays a site wiring fault message
Wiring faults detected include
missing ground, hot-neutral,
polarity reversal, and overloaded
neutral circuit.
If the UPS indicates a site wiring fault, have a qualified electrician inspect the
building wiring. Applicable for 120 V units only.
Problem and Possible Cause Solution