User Manual

ManualsBrandsAPC ManualsComputer Accessories & PeripheralsAPC UPS 1500VA Smart-UPS with SmartConnect, Pure Sinewave UPS Battery Backup, Uninterruptible Power Supply (SMT1500C)

Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower / Rack-Mount 2U20

SmartConnect

APC SmartConnect allows you to monitor the health and status of your UPS from any device connected to the

Internet. Visit www.smartconnect.apc.com to learn more.

Emergency Power Off

Overview

The Emergency Power Off (EPO) option is a safety feature that will immediately shut off power to all connected

equipment. When the EPO button is pushed, all connected equipment will immediately turn off and will not switch

to battery power.

Connect each UPS to the EPO switch. In configurations where multiple units are connected in parallel, each UPS

must be connected to the EPO switch.

The UPS must be restarted for power to return to connected equipment. Press the

ON/OFF button on the front panel

of the UPS.

Normally open contacts

1. If the EPO switch or relay contacts are normally open, insert the wires from the

switch or contacts at pins 1 and 2 of the EPO terminal block. Use 16-28 AWG

wire.

2. Secure the wires by tightening the screws.

If the contacts are closed, the UPS will turn OFF and power will be removed from the

load.

Load Shed Time

when On Battery

Disabled Set the value in

seconds

The amount of time the outlets will function on battery

power before they will turn off.

Load Shed On

Runtime

Disabled • Shutdown with

delay

• Shutdown

immediately

• Turn off

immediately

• Turn off with delay

•Disabled

When the battery runtime falls below the specified value,

the Controlled Outlet Group will turn off.

Configure this time using the L

OAD SHED RUNTIME

EMAINING setting.

Load Shed On

Runtime

Remaining

Disabled Set the value in

seconds

When the remaining runtime reaches this level, the

Controlled Outlet Group will turn off.

Load Shed on

Overload

Disabled • Disabled

• Enabled

In the event of an overload (greater than 100% output

power), the Controlled Outlet Group will immediately turn

off to conserve power for critical loads. The Controlled

Outlet Group will only turn on again with a manual

command.

CAUTION

RISK OF ELECTRIC SHOCK

• Adhere to all local and national electrical codes.

• Wiring should be performed by a qualified electrician.

• Always connect the UPS to a grounded outlet.

Failure to follow these instructions can result in minor or moderate injury.

Function Factory Default Options Description