User's Manual

Smart-UPS C 1000/1500 VA 120/230 Vac Tower / Rack-Mount 2U 9
Status Indicators
Display panel features
Display icons
1000/1500 VA 120 Vac 1000/1500 VA 230 Vac

On Line/On Battery LED

Display interface

POWER ON/OFF button

MENU button

Site Wiring Fault/System Alert LED

MUTE/ENTER button
Note: Refer to “Display Menu” section on page 11 in this manual for a detailed description of the front panel
buttons and icons.
Status LED
Audible Indicator
On Audible Indicator Terminates
Power On
The UPS is supplying AC power
to connected equipment.
The On Line/On
Battery LED
illuminates green.
None N/A
On Battery
The UPS is supplying battery
power from the internal battery.
The On Line/On
Battery LED
illuminates amber.
The UPS beeps 4 times
every 30 seconds.
The beeping stops when AC power is
restored or the
MUTE button is
pressed for two seconds.
System Alert
The UPS detects an internal
system error. Refer to “System
Errors and Message Codes” .
System Error LED
illuminates red.
Constant tone (for
severe errors only)
The alarm stops when the
POWER
ON/OFF button is pressed for two
seconds. This creates a System
Error Reset.
120 Vac 230 Vac Description
On Line: The UPS is supplying conditioned AC power to connected equipment.
Green mode: The UPS is operating at the most efficient level by bypassing unused
AVR components while acceptable AC voltage is present. The UPS will enter and
exit Green mode automatically and will not compromise power protection.
Load Capacity: The load capacity percentage is indicated by the number of load bar
sections illuminated. Each bar represents 20% of the load capacity.
Estimated Run Time / Min: This indicates the battery runtime minutes that remain
if the UPS switches to battery power.
Battery Charge: The battery charge level is indicated by the number of bar sections
illuminated. When all five blocks are illuminated, the battery is fully charged. Each
bar represents 20% of the battery charge capacity.
su0740d
su0740c