User manual
Table Of Contents
- Introduction
- Overview
- Unpack package contents
- Read the Safety Guide before installing the UPS.
- Hardware supplied
- Accessories
- Install accessories prior to connecting power to the UPS.
- Optional accessories
- Specifications
- Environmental Specifications
- Physical Specifications
- Front and rear panels
- Installation
- Output hardwire instructions
- Input hardwire instructions
- Connect the internal battery charger
- Tower configuration
- Install stabilizer brackets
- Install display panel
- Install bezel
- 2-post rack-mount configuration
- Remove and rotate display panel
- Position UPS for mounting in rack
- Install rack-mount brackets
- Secure 2-post rack to floor
- Install UPS in rack
- Install display panel
- Install bezel
- Start-up
- Connect equipment and external battery packs to UPS
- Prior to connecting the grounding cable, ensure that the UPS is NOT connected to utility or battery power.
- Start the UPS
- Operation
- Front panel display
- Display panel function buttons and indicators
- UPS function buttons
- UPS indicators
- Configuration
- UPS Settings
- Settings are adjusted through PowerChute software or optional SmartSlot accessory cards.
- Emergency Power Off (EPO)
- Connect the EPO
- External batteries
- APC battery solution
- Third party battery solution
- Connect the UPS to a battery system
- Configure UPS parameters
- Troubleshooting
- Transporting the UPS
- Prepare the UPS for transport
- Regulatory Agency Approvals and Radio Frequency Warnings
- Class A
- Service
- Contact Information
- Two-Year Warranty

User Manual Smart-UPS RC UXI/UXICH 1000/2000/3000 VA 220/230/240 Vac Tower/Rack-Mount 4U 3
Introduction
Overview
The American Power Conversion (APC
®
) Smart-UPS
®
RC is a high performance uninterruptible power
supply (UPS) that provides protection for electronic equipment from utility power blackouts, brownouts,
sags and surges. The UPS protects electronic equipment from small utility fluctuations and large
disturbances by providing continuous on-line double converted power. The UPS provides battery backup
until utility power returns to safe levels or the batteries are fully discharged.
Unpack package contents
Read the Safety Guide before installing the UPS.
Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the UPS package contents:
NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an
additional label is located on the chassis under the front bezel.
Accessories
Install accessories prior to connecting power to the UPS.
Refer to the APC Web site, www.apc.com for available accessories.
Optional accessories
• External battery pack
• 4-post rail kit
• 600 W internal battery charger
•UPS
• Front bezel
• Front panel display
• External battery cable
• Serial cable
• Rack-mount/stabilizer brackets
• Hardware supplied listed in table below
• Literature kit containing:
– Product documentation
–Smart-UPS
®
RC User Manuals CD
– PowerChute
®
Utility CD
– Safety information
– Warranty information
8
2
2
su0211b
Hardware supplied
Rack-mount configuration:
Pan head screws for securing rack-mount brackets to unit
Tower configuration:
Flat head screws for securing stabilizer brackets unit
Rack-mount configuration brackets
Tower configuration stabilizer brackets