User manual

SRC96XLBP / SRC96XLBP2S User Manual 6
Install and connect batteries
This unit is equipped with battery modules.
Install batteries into unit beginning with batteries at the
bottom.
Each string must be connected to battery connectors on
chassis.
1. Install batteries.
2. Connect batteries.
3. Replace battery compartment door and secure
door with screws previously removed.
Install bezel
1. Fit three tabs on the bottom inside edge of bezel into slots in
chassis.
2. Tip bezel forward. Fit two tabs on top inside edge of bezel into
slots in chassis and snap bezel into position.
2-post rack-mount configuration
This unit is intended for installation in a 19”, two-post or four-post rack.
For details on 4-post rail and rack installation refer to instructions in rail kit.
Remove stabilizer brackets if they are installed. Remove four screws that secure each bracket.
su0213a
x2
x2
x2
su0225a
su0216a