User`s manual

SAS / SATA II NAS System
User’s Manual
245
11.2.2 Procedure for Setting Up proNAS HA
Setting up a server cluster:
Below are the basic steps in setting up a server cluster:
1. Configure the hostname for both proNAS servers (must be unique).
2. Configure two static IP addresses for each proNAS server.
3. Set up private net. At least the private net IP must be configured to start cluster.
4. Start proNAS HA service for both proNAS servers. Select System Manager, and
then Services tab, and highlight proNAS HA service then click Start. proNAS HA
node will then appear on the left tree after the service starts successfully.
5. On the designated Active Server, go to proNAS HA->"General Settings".
6. On the "General Setting" tab, click "Edit" button. Input the Peer Server hostname
then select "Active(local-host) – Standby(peer host) Mode" under the
Cluster mode. Click "Save".
NOTE: The Cluster Mode of Backup Server must be configured as
“Standby(local host) – Active(peer-host) Mode” (see Step 10).
Other configuration options:
Computer Name:
Local Server: The hostname of the Active or Primary server
Peer Server: The hostname of the Backup or Secondary server