User manual

- 62 -
4.6.2 Upgrade
“Upgrade” can upgrade firmware. Please prepare new firmware file named
“xxxx.bin” in local hard drive, then click “Browse” to select the file. Click “Confirm”,
it will pop up a message “Upgrade system now? If you want to downgrade to the
previous FW later (not recommend), please export your system configuration in
advance”, click “Cancel” to export system configuration in advance, then click “OK”
to start to upgrade firmware.
Figure 4.6.2.1
Figure 4.6.2.2
When upgrading, there is a progress bar running. After finished upgrading, the
system must reboot manually to make the new firmware took effect.
4.6.3 Reset to factory default
“Reset to factory default” allows user to reset controller to factory default setting.
Figure 4.6.3.1
Reset to default value, the password is: 0000, and IP address to default DHCP.
Default IP address: 192.168.10.50 (DHCP)
Default subnet mask: 255.255.255.0
Default gateway: 192.168.10.254
Tips
Please contact with [e-mail] for latest firmware.
RAG362