System information

Using the LCD Console
3-6
3.3.4 Terminal Port Settings
To configure the settings of terminal port, enter the Terminal Port menu. Specify the following items one by one.
Use the UP and DOWN buttons to scroll through the options. Press the ENT button to select it. To cancel the selection
and return to the previous level, press the ESC button.
3.3.5 System Settings
In the System Setup menu, users are allowed to change the password settings, save or restore the configurations to
NVRAM, reboot and power off the system. See the following table for details of each option.
Use the UP and DOWN buttons to scroll through the items and options. Press the ENT button to select. To cancel the
selection and return to the previous level, press the ESC button.
3.3.6 System Information
The System Info menu provides the following information. Use the UP and DOWN buttons to scroll through each of
them. Users are allowed to modify the model name of the system and controller.
* Line 1 shows the controller A information, and Line 2 shows the controller B information.
Baud Rate 2400, 4800, 9600, 19200, 38400, 57600, 115200 (default)
Stop Bit 1 (default), 2
Data Bit 7, 8 (default)
Parity NONE (default), ODD, EVEN
Flow control OFF (default), H/W
Password Passwd ENABLE: YES (default) / NO
Enable or disable the password check when logging in menu.
Change Passwd
Key in the new password. The maximum length of password is eight characters. Press
and hold the ESC button to backspace continuously and return to the previous level.
Save Config Save to NVRAM: NO (default) / YES
Save configurations to NVRAM.
Restart: NO (default) / YES
Reboot the system.
Factory: NO (default) / YES
Restore the factory settings to NVRAM.
Shutdown NO (default) / YES
Power off the system.
Sys. Model Name Display and modify system model name.
Controller Model* Display and modify controller model name.
Boot Code* Display boot code version.
F/W Version* Display firmware version.
RAM* Display system memory size.
BP ID* Display backplane ID number.
IP Address* Display controller IP address