System information

Using the RAID GUI
2-13
2.3.3 Monitor mode
When SAS JBOD chassis are connected, the
enclosure tabs will appear in the Monitor Mode
(see Figure 2-16). Each tab view displays
different information for each connected
enclosure. Click the Enclosure 0 tab to view the
information of the local RAID subsystem. Click
the Enclosure 1, Enclosure 2, or Enclosure 3
tabs for a brief view of the connected SAS JBOD.
Each SAS JBOD has an unique chassis
identifier, which can be detected automatically by
the GUI when connected. The chassis identifier
corresponds to the enclosure tab number shown
in the GUI. In this way, users can identify and
manage each SAS JBOD easily and correctly.
However, the enclosure tabs are always
displayed in ascending order of chassis
identifiers instead of the chassis connection
order.
The number of enclosure tabs may be different
according the number of connected SAS JBOD chassis. For more information, see • For redundant controller with
redundant JBODs.
Figure 2-17 displays the Config Mode when a SAS enclosure is connected. Use the drop-down menu at the top of the
page to select the enclosure ID you wish to configure.
2.3.4 Information icons
In Monitor Mode, the following information icons are displayed on the screen. When components are working normally,
their icons are shown in green. When components fail to work, the icons are shown in red. Click on each icon for detailed
information.
Note
In order to use the expansion port on the SAS controller, you must have firmware version 1.20 or
later for complete functionary.
Icon Name Detailed Information
Temperature
• Sensor
• Current
• Non-critical
• Critical
Table 2-8 Information icons (in SAS monitor mode)
Figure 2-16 SAS enclosure monitor mode
Enclosure tabs
Figure 2-17 SAS enclosure configuration mode
Enclosure ID drop-down menu