System information

Appendix
D-48
Event ID
0x281c
Type
ENCLOSURE
Severity
INFO
Parameters
Message
UPS battery back to normal
Description
UPS battery charge back to normal range.
Advice
None
Event ID
0x281d
Type
ENCLOSURE
Severity
WARNING
Parameters
Message
UPS battery will fail
Description
The UPS has a battery that will fail.
Advice
Replace the UPS battery as soon as possible.
Event ID
0x281e
Type
ENCLOSURE
Severity
INFO
Parameters
Message
UPS battery replace back to non-failure status
Description
The UPS is replaced and back to non-failure status.
Advice
None
Event ID
0x281f
Type
ENCLOSURE
Severity
WARNING
Parameters
Message
UPS overload
Description
The UPS overload.
Advice
(1) If overload occurs immediately after connecting new equipment to the UPS, the UPS cannot
support the new load. You must connect one or more devices to a second UPS, or replace the cur-
rent UPS with a model that can support a larger load.
(2) If the overload was not caused by adding new load equipment, run a UPS self-test to see if the
problem clears. If the test fails (an overload still exists), close all open applications at the UPS load
equipment and reboot the UPS. If the problem persists, disconnect all equipment from the UPS
and reboot the UPS. If the overload still exists, the UPS needs to be repaired or replaced. Contact
the UPS vendor support for assistance. If the problem is cleared, reconnect and turn on the load
equipment, one piece at a time, to determine which piece of equipment caused the overload.
Event ID
0x2820
Type
ENCLOSURE
Severity
INFO
Parameters
Message
UPS overload solved
Description
The UPS overload solved.
Advice
None