System information

Appendix
D-33
SAS
• Hosts
Event ID
0x3009
Type
HOST
Severity
WARNING
Parameters
Chip ID, Control-
ler ID
Message
Reset host i/f chip x in controller y
Description
The controller resets chip x that failed to execute commands properly. This could be to recover
from a transient error due to unstable channel or heavy traffic. The controller will resume normal
operations of the chip after reset; however, this could result in performance drop of the LUNs
exported to the host ports of this chip.
Advice
If this event occurs often, check the host connectivity, or contact local sales or support office.
Event ID
0x300a
Type
HOST
Severity
FATAL
Parameters
Chip ID, Control-
ler ID
Message
Host i/f chip x in controller y failed
Description
The controller cannot execute commands properly on chip x after all appropriate recovery proce-
dures were conducted. This could be resulted from unstable power supply to the system. All LUNs
controlled by the chip will be unavailable to hosts.
Advice
Check power supply, replace with a new controller, or contact local sales or support office.
Event ID
0x300b
Type
HOST
Severity
ERROR
Parameters
Host Channel ID,
Controller ID, Error
Code
Message
Host channel x in controller y PCI Error: z
Description
The controller has detected error in the host channel.
Advice
Check if the power supply is stable. Contact local sales or support office.
Event ID
0x300c
Type
HOST
Severity
INFO
Parameters
Host WWPN, Host
Port ID
Message
Host x detected on host port y
Description
The controller detected host x on host port y. The host can start access the controller over the host
port.
Advice
None