System information

Appendix
C-2
C.1 (N) Set IP address
The Boot Utility allows you to update the Boot ROM and System ROM. First you need to set the controller and server IP
addresses. Press [N] to enter the settings.
1. Set the Board IP address and press [Enter].
2. Set the Server IP address and press [Enter].
3. Press [Y] to save the settings.
If your system supports redundant controller, press [N] and you are required to set the following IP addresses.
1. Set the Server IP address and press [Enter].
2. Set the Local IP address and press [Enter].
3. Set the Local IP mask address and press [Enter].
4. Set the Gateway address and press [Enter].
C.2 (L) Load Image by TFTP
Before a Boot ROM or System ROM update, you need to set up the TFTP server for loading a new firmware image. Follow
the steps below to load an image:
1. Open the TFTP Server, click the Browse button to set the boot code or firmware image directory. You can use the
Show Dir button to see the files in the directory.