System information

Using the CLI Commands
4-30
4.11 Configuration shortcuts
4.11.1 RAID quick setup
4.11.2 Performance profile
4.12 Snapshot
Command
raidquick
Synopsis
raidquick [-r raidlevel] [-i initopt] [-s spare_no]
Description
Initialize RAID configurations and LUN mapping according to the specified.
[For single controller model]
A volume (for raid30, raid50, or raid60) or a logical disk (for other RAID levels) will be
created with all capacity of all local data member disks and it will be mapped to the LUN 0 of
the default storage group of all host ports. All other controller configurations will remain
unchanged and all RAID parameters will use the default values. If there is any error during
the quick setup, all hard disks will return to the unused state.
[For Redundant controller model]
Two volumes (for raid30, raid50, or raid60) or two logical disks
(for other RAID levels) will be created with all capacity of all local data member disks and
the preferred controller of one volume or logical disk is assigning to controller A and the
other one is assigned to controller B. They will be mapped to the LUN 0 and LUN 1 of the
default storage group of all host ports on both controllers for MPIO failover mode or to the
LUN 0 of the default storage group of all host ports on the preferred controller for Multiple-
ID failover mode. All other controller configurations will remain unchanged and all RAID
parameters will use the default values. If there is any error during the quick setup, all hard
disks will return to the unusedstate.
Parameters
[-r raidlevel]: RAID level
[-i initopt]: initialization method
[-s spare_no]: the number of global spare disks.
Command
perfprofile
Synopsis
perfprofile [avstream/maxiops/maxthruput/off]
Description
Select the performance profile to apply
Parameters
[avstream/maxiops/maxthruput/off]: AV application, maximum IO per second, maximum
throughput, or off.
Command
svpcreate
Synopsis
svpcreate pdevice sdevice
Description
Create a snapshot volume pair.
Restrictions
pdevice and sdevice must not be a private virtual disk.
sdevice must not be used by any LUN.
pdevice and sdevice must not be in faulty and regular initialization state.
The capacity of sdevice must be greater than 10% of the capacity of pdevice.
Command
svpdelete
Synopsis
svpdelete pdevice
Description
Delete a snapshot volume pair.
Restrictions
There must be no snapshot volume on the volume pair.