System information

Using the CLI Commands
4-25
4.9 System Management
4.9.1 Configurations management
Command
autoshutdown
Synopsis
autoshutdown [on/off] [-e upsac/fan/temp] [-t xxmin]
Description
Review or set the auto shutdown function.
Parameters
[on/off]: enable or disable the auto shoutdown function
[-e upsac/fan/temp]: event to trigger auto shutdown. (UPS AC power loss and then low
battery or UPS connection loss, all fan failure, or over temperature)
[-t xxmin]: shutdown delay time
Command
configrestore
Synopsis
configrestore [-h]
Description
Erase all configurations on NVRAM or hard disks and restore to factory default.
Parameters
[-h]: erase configurations on all hard disks instead of NVRAM
Command
configerase
Synopsis
configerase hddx hddy …
Description
Erase controller’s configurations stored on hard disks.
Parameters
[-f]: force to erase. If this option is specified, the configurations on the hard disk will be
unconditionally erased.
Command
configtohdd
Synopsis
configtohdd hddx
Description
Save NVRAM configurations to a hard disk.
Command
configfromhdd
Synopsis
configfromhdd hddx
Description
Restore NVRAM configurations from hard disks.
Command
configget
Synopsis
configget config.bin
Description
Get main configurations stored on NVRAM and save to a file, config.bin.
Command
configset
Synopsis
configset config.bin
Description
Store a file, config.bin, as the controller’s main configurations on NVRAM.
Command
configtext
Synopsis
configtext config.html
Description
Get the main configurations and save to a html file.
Command
configtextmail
Synopsis
configtextmail account
Description
Get the main configurations and save to a text file, which is then sent to the specified mail
receiver.