Specifications

Chapter 4 Subsystem Connection and Operation
4.3.5 LCD Screen
When powering on the subsystem, the following messages should appear on the front
panel LCD screen. Wait for the front panel LCD to show “READY” or “No Host LUN”
before the host boots up. Refer to Figure 4-13 on how to read the screens.
Model Name
Ready
Status/Data Transfer Indicator
Figure 4-13: The LCD Start-up Screen
The LCD screen startup sequence is shown and described in the sequence below.
Initializing.
Please Wait...
Power on Self
Test, Please Wait..
Power on Self
Test Completed
24 BAYG2421
256MB RAM, Wait
24 BAYG2421
No Host LUN
This screen appears when the PSUs are
turned on.
This screen appears when the subsystem
is testing the integrity of the firmware and
hardware components.
This screen appears after the self test is
completed.
This screen shows the memory size. If
properly initialized, the subsystem should
correctly indicate the memory size now.
System is ready. You can now start to
configure the subsystem.
4-13