Specifications

Figure 2-15: Power Cord, Cable Clamp and Cable Strap Positions
Step 2. Connect the cable clamp to the cable strap. Insert the flat angled end
of the cable strap through the small opening (the tie head) underneath
the cable clamp with the smooth side of the strap facing up and the
ribbed side facing down and the release tab at the end. Press down the
release tab to adjust the position of the cable clamp along the strap.
See the diagram below.
Figure 2-16: Inserting Cable Strap into Cable Clamp
Step 3. Mount the cable strap to the chassis by inserting the push-in barb
anchor into the pre-drilled hole underneath the power supply.
Power Cord Cable Clamp Installation
2-17