Specifications

Figure 2-12: Removing the BBU Module
Step 2. Once the dummy cover has been removed from the controller module,
unpack the BBU module package. Carefully align and insert the BBU
into the module slot and fasten the spring screw to secure the BBU.
Once properly installed and after the subsystem is powered on, the
status LED on BBU should start blinking, indicating it is charging the
batteries inside.
Figure 2-13: Installing a BBU Module
2.10. Power Cord Cable Clamp Installation
Several cable clamp assemblies are included in the accessories boxes in the 24 BAY
shipping package. When installing the subsystem, it is recommended to secure all power
Power Cord Cable Clamp Installation
2-15