Specifications

Figure 2-4: Accessing a DIMM Module
Step 5. Install the replacement DIMM module. Carefully remove the
replacement module from its anti-static bag. Grasp the module by
edges. Make sure the white, plastic ejectors on the sides of DIMM
socket are open. Carefully align the DIMM module to the socket.
Pressing firmly on both ends, push the module into the socket until the
ejectors return to the closed position.
Step 5. Install the controller and the BBU module (if installed). Proceed
with the following to install the controller:
1. Insert the controller into the respective module slot with the
ejector levers at the lowest position.
2. Push the controller in until you feel contact resistance with its
back-end connectors.
3. Use the ejector levers on the sides to secure the controller into the
chassis slot. Make sure the squared notch of the ejector levers
locks onto the metal groove on the interior sides of the module
slot. Once in place, pull the ejector levers in an upward motion to
secure the controller.
4.
Insert and fasten the retention screws underneath each ejector
lever to secure the modules. After the controller is properly
installed, install the BBU module and secure it with the spring
screw.
Memory Module Installation
2-9