Specifications

Falcon 24 Bay SCSI-SATA Installation and Hardware Reference Manual
 Drive trays (2 LEDs)
 BBU module (optional FRU; 1 LED)
1.3.3 Firmware and RAIDWatch
®
GUI
Firmware: The firmware (FW) is pre-installed software that is used to configure the
subsystem. The FW can be accessed through either the front panel LCD keypad or a
terminal emulation program that is installed on an external computer/application server
used as a management station.
RAIDWatch: RAIDWatch is a premier, web-based graphics user interface (GUI) that can
be installed on a remote computer and accessed via standard TCP/IP.
1.3.4 Audible Alarm
The 24 BAY subsystem comes with audible alarms that are triggered when certain
active components fail or when certain controller or subsystem thresholds are exceeded.
When you hear an audible alarm emitted from the subsystem, it is imperative that you
determine the cause and rectify the problem immediately.
WARNING!
Failing to respond when an audible alarm is heard can lead to permanent subsystem
damage. When an audible alarm is heard, rectify the problem as soon as possible.
1.4. Hot-swappable Components
1.4.1 Hot-swap Capabilities
The 24 BAY subsystem comes with hot-swappable components that can be
exchanged while the subsystem is still online without affecting the operational
integrity of the subsystem. These components should only be removed from the
subsystem when they are being replaced. At no other time should these components
be removed from the subsystem.
1.4.2 Components
The following components are all hot-swappable:
 PSU modules
1-14