Specifications

Falcon 24 Bay SCSI-SATA Installation and Hardware Reference Manual
The RAID controller module comes with two (2) RS-232C (audio jack) serial ports, one
(1) RJ-45 Ethernet connector, and status-indicating LEDs located on its rear-facing
faceplate.
1.1.2.6 The Backplane Board
An integrated backplane board receives disk drives on the front end and connects the
RAID controller, cooling, and PSU modules on the rear end. The PCB board provides
logic level signals and low voltage power paths. It contains no active electronics and no
user-serviceable components.
1.1.2.7 Subsystem Rack/Cabinet Installation
The 24 BAY subsystem chassis has pre-drilled screw holes for slide rail
mounting. Separately purchased, independently installed RAID slide rails are available for
rack or cabinet installation. Available RAID slide rails are listed below:
 IFT-9274CSlider36-0010
 IFT-9274CSlider32-0010
The slide rails come with their own installation instructions.
1.2. Subsystem Components
1.2.1 LCD Keypad Panel
Figure 1-6: LCD Keypad Panel
The LCD keypad panel shown in Figure 1-6 consists of an LCD display with push
buttons and LEDs that indicate array status. The LCD panel provides full access to all
RAID configurations and monitoring options. After powering up the subsystem, the
1-6
Subsystem Components