Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
5.8 Replacing a Dongle Kit
If a dongle kit is damaged or broken, it needs to be replaced. To replace the
dongle kit, please follow these instructions:
1. Remove the drive tray from the subsystem.
2. Remove the hard drive from the drive tray. (See Section 5.7)
3. Remove the three (3) dongle kit retention screws. Turn the drive tray
over and remove these screws.
Figure 5-24: Removing the Retention Screws
4. Install the new dongle kit using the instructions given in Section 2.8.2.
5. Install the hard drive to the drive tray. See Section 2.8.4.
6. Install the drive tray with the hard drive to the chassis. See Section
2.9.
5-16
Replacing a Dongle Kit