Product specifications

Chapter 5: Subsystem Maintenance
Figure 5-21: Front View of an Individual Drive Tray
4. Remove the drive tray with the hard drive, gently and carefully
withdrawing the drive tray with hard drive from the chassis.
5. Remove the four (4) retention screws located on the sides of the drive
tray (two on each side.) (See Figure 5-22)
Figure 5-22: Removing the SATA Hard Drive
6. For PATA drives, once the hard drive has been removed from the drive
tray, disconnect the drive from the dongle board. (See Figure 5-23)
Figure 5-23: Removing the PATA Hard Drive
7. Install the new hard drive. Please refer to the complete hard drive
installation procedures in Section 2.8.
Replacing a Failed Hard Drive
5-15