Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
3. Remove the PSU retention screw at the top right-hand side of the PSU.
(See Figure 5-12)
Figure 5-12: Removing the PSU Retention Screw
4. Remove the PSU module by pressing down the PSU handle found on
the top of the PSU. (See Figure 5-13) This will dislodge the PSU
module from the subsystem.
PSU Handle
Figure 5-13: Pressing Down the PSU Handle
5. After the PSU module has been dislodged from the enclosure, use the
handle to gently pull the PSU module out of the enclosure. (See
Figure 5-14)
Figure 5-14: Dislodging the PSU
6. Remove the cooling module from the lower level of the PSU module.
Please refer to Section 5.6.
WARNING!
When a PSU is pulled out of the chassis, the cooling module beneath the
PSU is removed from the chassis at the same time.
It is recommended that the replacement procedure is completed in less
than five (5) minutes to prevent the subsystem from overheating.
5-10
Replacing a Faulty PSU Module