Product specifications

Chapter 5: Subsystem Maintenance
Figure 5-7: Installing the DIMM Module
4. Install the controller module. Once the new DIMM module has been
installed, place the controller module back in its original location. (See
Section 5.2.3)
5.4 Replacing a Faulty BBU Module
The BBU is an optional item for the FALCON II. It consists of a bracket, a
battery pack, and a PCB board that connects to the backplane board. If a
BBU was installed and has failed, it should be replaced. To install or replace
a BBU, please follow these steps:
CAUTION!
Please read and follow the warning and precautions listed in Section
2.7.2 when replacing a BBU.
1. Remove the faulty BBU from the chassis. Loosen the two (2) retention
screws located on both sides of the BBU, then pull out the BBU. (See
Figure 5-8)
Figure 5-8: Removing the BBU Module
2. Install the new BBU. Align the BBU with the slot, and then gently
push the BBU into the slot.
Replacing a Faulty BBU Module
5-7