Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
5.2.3 Replacing the Controller Module
If the controller module itself has failed, it must be replaced. To replace a
failed controller module:
1. Remove the controller module from the subsystem (see Section 5.2.2.)
If the DIMM module is undamaged it can be removed and reinstalled
on the new controller module. For instructions on removing and
installing a DIMM module, please see Section 5.3.
2. Install the DIMM module onto the new controller module, making sure
that the memory module is securely in place. (See Section 5.3)
3. Install the controller module. Make sure the levers at the back of the
controller module are down. Align the controller module with the
controller module bay at the rear of the subsystem. Gently slide the
controller module in. (See Figure 5-3)
Levers
Figure 5-3: Installing the Controller Module
4. Reposition the controller module. Once fully inserted, lift up the levers
at the back of the controller module. This will set the controller module
in the correct position. (See Figure 5-4)
Levers
Figure 5-4: Lifting the Controller Module Latches Upward
5. Secure the controller module to the subsystem. Install the two (2)
screws on the levers to secure the controller module in place. (See
Figure 5-5)
5-4
Replacing Controller Module Components