Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
WARNING!
The dongle kits are small, delicate components that must be handled with
care.
1. Installation: The dongle kit (IFT-9270AN1S1P-0010) shown in Figure
2-5 is mounted onto a metal base plate that has three (3) pre-drilled
holes reserved for retention screws.
Figure 2-5: SATA-to-PATA Dongle Kit
2. Three (3) corresponding pre-drilled screw holes are located at the back
of the drive tray shown in Figure 2-6.
Figure 2-6: Screw Locations on an Empty Drive Tray
3. Place the dongle kit at the back of the drive tray. Hold the dongle kit in
place and turn the drive tray over. Align the holes in the base of the
drive tray with the holes in the dongle kit base tray.
4. Insert the three (3) retention screws from the bottom of the drive tray.
These screws will firmly secure the dongle kit to the drive tray and
facilitate the installation of the appropriate drive. (See Figure 2-7)
2-10
Hard Drive Installation