Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
2. Using a screwdriver, loosen the two (2) retention screws located on
both sides of the dummy plate. (See Figure 2-2)
Figure 2-2: Loosening the BBU Retention Screws
3. Once the retention screws are loosened, remove the dummy plate from
the chassis. (See Figure 2-3)
Figure 2-3: Removing the BBU Slot Dummy Plate
NOTE:
It may be difficult to remove the dummy plate as it is embedded in the
subsystem chassis. If you are unable to dislodge the sheet, wedge the
head of a flat-head screwdriver between the metal sheet and the chassis
and then gently nudge the metal sheet out of the chassis.
4. Install the BBU. Align the BBU with the BBU slot. Gently insert the
BBU until the back of the BBU reaches the end of the slot.
5. Secure the BBU to the chassis. Fasten the two (2) retention screws on
the BBU rear panel to secure the BBU to the chassis. (See Figure 2-4)
Figure 2-4: Installing the BBU Module
2-8
BBU Installation