Product specifications

Falcon II SCSI-SATA Installation and Hardware Reference Manual
Figure 1-9: Controller Module Interfaces
• Host Ports: Two (2) SCSI-320 host channels (CH0 and CH1 in
Figure 1-9) connect the Falcon II subsystem to the host through two
(2) dual-stacked VHDCI SCSI connectors.
• Ethernet Ports: A single 10/100BaseT Ethernet port (located next
to COM2) is used for remote management through the network.
• COM ports: The controller module comes with two (2) COM
ports. One port is used to access the controller-embedded
configuration utility through the network, and the other connects to
a UPS connection. Please refer to Appendix A for the instructions
on connecting a UPS.
• Levers: Two (2) levers located in the sides of the controller board
rear panel provide easy controller module installation and secure
the controller module in place.
1.2.6 DIMM Module
The controller module comes with a pre-installed 256MB capacity or above
DDR RAM DIMM module and can support capacities up to 1GB. The
DIMM module is placed in an easily accessed location on the controller
board. However, when the DIMM module is being changed, the controller
module must be removed from the subsystem chassis.
1.2.7 BBU
PN: IFT-9273CBT-C
An optional, separately purchased Li-ION battery backup unit (BBU) (see
Figure 1-11) can sustain cache memory after a power failure. If you
purchased a BBU, it will be installed on the upper left side of the controller
module in the rear subsystem chassis. Please refer to Section 2.6 for
installation instructions.
1-8
FALCON II Subsystem
Components