User`s guide

Metered Rack PDU for High Density
11
Control console
After you log on at the control console, as described
in “Local access to the control console” on page 9 or
“Remote access to the control console” on page 10:
1. Choose Network from the Control Console
menu.
2. Choose TCP/IP
from the Network menu.
3. If you are not using a BOOTP or DHCP server
to configure the TCP/IP settings, select the
Boot Mode menu. Select Manual boot mode,
and then press
ESC to return to the TCP/IP
menu. Set the System
IP, Subnet Mask, and
Default Gateway address values. (Changes
will take effect when you log off.)
4. Press
CTRL+C to exit to the Control Console
menu.
5. Log off (option 4 in the Control Console
menu).
Note: If you disconnected a cable
during the procedure described in
“Local access to the control
console” on page 9, reconnect that
cable and restart the associated
service.