User Manual
Table Of Contents
- Safety and General Information
- Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.
- SAVE THESE INSTRUCTIONS - This section contains important instructions that should be followed during installation and maintenance of the UPS and batteries.
- Inventory
- Connect the Battery
- BR650MI /BR900MI
- BR1300MI / BR1600MI
- Install PowerChute™ Personal Edition Software
- Installation
- Connect the Equipment
- BR650MI / BR900MI
- BR1300MI /BR1600MI
- Operation
- Power saving display
- Unit sensitivity
- Front panel buttons and display interface
- Alarms and System Errors
- Audible indicators
- Status icons
- System errors
- Function Button Quick Reference
- Troubleshooting
- Specifications
- Battery Replacement
- Warranty
- APC by Schneider Electric IT Customer Support Worldwide
- User Manual Back-UPS™ Pro BR650/900/1300/1600MI
Back-UPS Pro BR650MI / BR900MI / BR1300MI / BR1600MI2
Connect the Battery
The UPS is shipped with the battery disconnected.
BR650MI /BR900MI
BR1300MI / BR1600MI
Remove the battery door.
Remove the battery. Connect the wire.
Push the battery into the unit.
Replace the battery door.
Remove the battery door.
Remove the battery.
Flip or turn the battery 180 degrees
upward/downward to let green side of the
label face up.
Push the battery into the unit.
Replace the battery door.
b
u
0
2
4
c
bu025c
bu026c
bu055b
bu057b
RED LABEL ON TOP
bu059b
bu058b
GREEN LABEL ON TOP
bu060b