User guide

User Guide InfraStruxure 150kVA Power Distribution Unit 26

tcpip6

Access: Administrator only

Description: Enable IPv6 and view and manually configure these network settings for the PDU:

Example 1: To view the network settings of the PDU, type tcpip6 and press ENTER.

Example 2: To manually configure an IPv6 address of 2001:0:0:0:0:FFD3:0:57ab for the PDU, type:

tcpip -i 2001:0:0:0:0:FFD3:0:57ab

user

Access: Administrator only

Description: Configure the user name and password for each account type, and configure the inactivity

timeout.

Example 1: To change the Administrator user name to XYZ, type:

apc> user -an XYZ

E000: Success

Example 2: To change the log off time to 10 minutes, type:

apc> user -t 10

E000: Success

Option Argument Description

-S enable | disable Enable or disable IPv6.

-man enable | disable Enable manual addressing for the IPv6 address of the NMC.

-auto enable | disable Enable the NMC to automatically configure the IPv6 address.

-i <IPv6 address> Set the IPv6 address of the PDU.

-g <IPv6 gateway> Set the IPv6 address of the default gateway.

-d6 router | statefull |

stateless | never

Set the DHCPv6 mode, with parameters of:

router controlled,

statefull (for address and other information, they maintain their status),

stateless (for information other than address, the status is not maintained ),

never.

Option Argument Description

-an

-dn

-rn

<read-only name>

Set the case-sensitive user name for each account type. The maximum

length is 10 characters.

-ap

-dp

-rp

<read-only password>

Set the case-sensitive password for each account type. The maximum

length is 32 characters. Blank passwords (passwords with no characters)

are not allowed.

-t <minutes> Configure the time (3 minutes by default) that the system waits before

logging off an inactive user.