User guide

7User Guide InfraStruxure 150kVA Power Distribution Unit
• The User field reports whether you logged in through the Administrator or Device Manager
account. (The Read Only User account cannot access the command line interface.)
When you log on as Device Manager (equivalent to Device User in the Web interface), you can
access the event log, configure some settings, and view the number of active alarms.
User : Administrator
• The Stat field reports the PDU status.
Stat:P+ N+ A+
If P+ is not displayed, contact APC support.
Using the Command Line Interface
Logging in
On initial access to the PDU via a serial, Telnet, or SSHv1/v2 connection the user will be prompted to
login. The user name prompt will be: User Name: Type in your user name and press
ENTER. The
password prompt is Password: If your user name and password are valid, then you will be logged into
the command line interface.
The PDU command line interface prompt is: apc>
Command errors
If the user enters a command that does not exist, then the following error message will be displayed:
E101: Command Not Found.
The existence of commands can be probed by requesting help for the command (help <command>). If
the command exists, then its help is displayed, else the message:
"
E102: Parameter Error" is displayed.
P+ The APC operating system (AOS) is functioning properly.
IPv4
only
IPv6
only
IPv4 and
IPv6*
Description
N+ N+ N4+ N6+ The network is functioning properly.
N? N6? N4? N6? A BOOTP request cycle is in progress.
N– N6- N4- N6- The PDU failed to connect to the network.
N! N6! N4! N6! Another device is using the PDU IP address.
* The N4 and N6 values can be different from one another: you could, for example, have
N4- N6+.
A+ The application is functioning properly.
A– The application has a bad checksum.
A? The application is initializing.
A! The application is not compatible with the AOS.