User guide

User Guide InfraStruxure 150kVA Power Distribution Unit 96
Use the Wizard
Note: Most software firewalls must be temporarily disabled for the Wizard to discover unconfigured
PDUs.
Launch the Wizard
The installation creates a shortcut link in the Start menu to launch the Wizard.
Configure the basic TCP/IP settings remotely
Prepare to configure the settings. Before you run the Wizard:
1. Contact your network administrator to obtain valid TCP/IP settings.
2. If you are configuring multiple unconfigured PDUs, obtain the MAC address of each one to
identify it when the Wizard discovers it. (The Wizard displays the MAC address on the screen on
which you then enter the TCP/IP settings.)
– The MAC address is on a label on the PDU.
– You can also obtain the MAC address from the Quality Assurance slip that came with the
PDU.
Run the Wizard to perform the configuration. To discover and configure unconfigured PDUs over
the network:
1. From the Start menu, launch the Wizard. The Wizard detects the first PDU that is not configured.
2. Select Remotely (over the network), and click Next >.
3. Enter the system IP, subnet mask, and default gateway for the PDU identified by the MAC
address. Click Next >.
On the Transmit Current Settings Remotely screen, if you select the Start a Web browser
when finished check box, the default Web browser connects to the PDU after the Wizard
transmits the settings.
4. Click Finish to transmit the settings. If the IP address you entered is in use on the network, the
Wizard prompts you to enter an IP address that is not in use. Enter a correct IP address, and click
Finish.
5. If the Wizard finds another unconfigured PDU, it displays the screen to enter TCP/IP settings.
Repeat this procedure beginning at step 3, or to skip the PDU whose MAC address is currently
displayed, click Cancel.