User`s guide

®
USER’S GUIDE
Switched Rack PDU
44
Outlet Settings for Outlets and Outlet Groups
Initiate a control action
Web interface. To control the outlets on your Switched Rack PDU:
1. From the Device Manager tab, select Control from the left navigation menu.
2. Mark the checkboxes for each individual outlet or outlet group to control, or select
the All Outlets checkbox.
3. Select a Control Action from the list, and click Next >>. On the confirmation page
that explains the action, choose to apply or cancel it.
Control Console. Select Outlet Control/Configuration from the Device Manager
menu to display a list of outlets. For each outlet, the list indicates whether it is a
member of an outlet group.
1. Choose either of the following:
–To control one outlet and the outlet group, if any, to which it belongs, select the
number of the outlet, and then select Control Outlet.
–To control all outlets, select Master Control/Configuration, and then Control of
ALL Outlets.
2. Select a control action.
3. On the confirmation screen that describes the action to be executed, type Yes at
the prompt to perform the action.
If you apply an outlet control action to outlets or outlet groups, the
following delays are used for the action:
• For an individual outlet (not in an outlet group), the action uses the
delay periods and reboot duration configured for that outlet.
• For a global outlet group, the action uses the delay periods and
reboot duration configured for the global outlet.
• For a local outlet group, the action uses the delay periods configured
for the lowest-numbered outlet in the group.