Installation manual

Installation Manual
11
How to Recover from a Lost Password
You can use a local computer that connects to the Management Card through
the serial port to access the command line interface.
1. Select a serial port at the local computer, and disable any service that
uses that port.
2. Connect the provided serial cable (APC part number 940-0299) to the
selected port on the computer and to the configuration port at the
Management Card.
3. Run a terminal program (such as HyperTerminal
®
) and configure the
selected port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow
control.
4. Press
ENTER, repeatedly if necessary, to display the User Name
prompt. If you are unable to display the User Name prompt, verify the
following:
– The serial port is not in use by another application.
– The terminal settings are correct as specified in step 3.
– The correct cable is being used as specified in step 2.
5. Press the Reset button. The Status LED will flash alternately orange
and green. Press the Reset button a second time immediately while the
LED is flashing to reset the user name and password to their defaults
temporarily.
6. Press
ENTER, repeatedly if necessary, to display the User Name prompt
again, then use the default, apc, for the user name and password. (If
you take longer than 30 seconds to log on after the User Name prompt
is redisplayed, you must repeat step 5 and log on again.)
7. At the command line interface, use the following commands to change
the User Name and Password settings, both of which are now apc:
user -an yourAdministratorName
user -ap yourAdministratorPassword
For example, to change the Administrator user name to Admin,
type:
user -an Admin
8. Type quit or exit to log off, reconnect any serial cable you
disconnected, and restart any service you disabled.