Installation manual

10
Installation Manual
User interface display (Symmetra PX 250 or Symmetra PX 500 UPS)
To configure the IP address of a Network Management Card at the user
interface display of the Symmetra PX UPS:
1. If you plan to manually assign the network settings, contact your
system administrator to obtain a valid IP address, subnet mask, and
default gateway for the Network Management Card.
2. At the user interface display, press the UPS System icon.
3. Select Configuration, then User Configuration.
4. At the prompt, enter the user password for your UPS (apc, by default),
then select NMC Settings.
5. For the Network Management Card you are configuring, select
Configure NMC Settings.
6. In the Network settings mode drop-down list, select the network
configuration option for your system: Manual, BootP, DHCP, or
DHCP & BootP.
– If you select Manual, enter the IP address, subnet mask, and default
gateway you obtained in step 1.
– If you select BootP, DHCP, or DHCP & BootP, a DHCP or BOOTP
server will assign the IP address, subnet mask, and default gateway
for the Network Management Card.
7. Press Apply to save your changes.