User`s guide

®
USER’S GUIDE
Network Management Card
88
One of the following codes is sent when the UPS has a fault condition. Many conditions
apply only to specific UPS models or product lines.
Out-of-Band
Management Card
Network Management Card
Code Event Event Code Events
5 UPS FAULT 0x011B, 0x0120, 0x011F, 0x012F, 0x0126,
0x0128, 0x012A
UPS events generated by
faults of Smart-UPS or
Matrix-UPS models.
0x0201, 0x0203, 0x0205, 0x0207, 0x0209,
0x020B, 0x020D, 0x020F, 0x0211, 0x0213,
0x0215, 0x0217, 0x0219, 0x021B, 0x021D,
0x021F, 0x0221, 0x0223, 0x0225, 0x0227,
0x0229, 0x022B, 0x022D, 0x022F, 0x0231,
0x0233, 0x0235, 0x0237, 0x0239, 0x023B,
0x023D, 0x023F, 0x0242, 0x0244, 0x0246,
0x0248
UPS events generated by
faults of Symmetra UPS
models (single-phase
only).
0x0A01, 0x0A03, 0x0A05, 0x0A07, 0x0A09,
0x0A0B, 0x0A0D, 0x0A0F, 0x0A11, 0x0A13,
0x0A15, 0x0A17, 0x0A19, 0x0A1B, 0x0A1D,
0x0A1F, 0x0A21, 0x0A23, 0x0A25, 0x0A27,
0x0A29, 0x0A2B, 0x0A2D, 0x0A2F, 0x0A31,
0x0A33, 0x0A35, 0x0A37, 0x0A39, 0x0A3B,
0x0A3D, 0x0A3F, 0x0A41, 0x0A43, 0x0A45,
0x0A47, 0x0A49, 0x0A4B, 0x0A4D, 0x0A4F,
0x0A51, 0x0A53, 0x0A55, 0x0A57, 0x0A59,
0x0A5B, 0x0A5D, 0x0A5F, 0x0A61, 0x0A63,
0x0A65, 0x0A67, 0x0A69, 0x0A6B, 0x0A6D,
0x0A6F, 0x0A71, 0x0A73, 0x0A75, 0x0A77,
0x0A79, 0x0A7B, 0x0A7D, 0x0A7F
UPS events generated by
faults of Symmetra,
Symmetra 3-phase,
Silcon UPS, and AIS
5000 models.
For a list of supported events for a currently connected UPS model, retrieve
the config.ini file of the Management Card of that UPS, and see the list under
[EventActionConfig]. The event codes listed there use an initial E instead
of the 0x used in the event codes listed here, but otherwise they are the same.
To retrieve the file, see Retrieving in Retrieving and Exporting the .ini File.