User`s guide

®
USER’S GUIDE
Network Management Card
87
Conversion of event codes. If Send Out-of-Band Management Event Codes is
enabled for a paging recipient, any Network Management Card event code is
converted automatically to a default Out-of-Band Management Card event code in
paging notifications to that recipient.
One of the following event codes is sent when the UPS starts up, shuts down,
switches to battery operation, or has a battery-related problem.
Because an Out-of-Band Management Card does not have event codes for
the Integrated Environmental Monitor (IEM) of an AP9618 or AP9619
Network Management Card, codes 16 through 19 in the last of the following
tables have been created to enable the conversion of Network Management
Card event codes from the IEM to codes compatible with numeric pagers.
Out-of-Band Management Card Network Management Card
Code Event Code Event
0 UPS ON-BATTERY 0x0109 UPS: On battery power in response to an input
power problem.
1 AC FAIL/LOW BATTERY 0x010F UPS: The battery power is too low to continue to
support the load; the UPS will shut down if input
power does not return to normal soon.
2 UPS SHUT DOWN 0x0114 UPS: The output power is turned off.
3 UPS ON-LINE 0x010A UPS: No longer on battery power.
0x0113 UPS: The output power is now turned on.
4 REPLACE BATTERY 0x0119 UPS: At least one faulty battery exists.