User`s guide

®
USER’S GUIDE
Network Management Card
85
Configure settings for the mode you selected (Analog Mode or TAP Mode).
Analog Mode
Setting Description
Dial String A character string that the modem of the Management Card uses to contact this
recipient. The string must include the following:
• The phone number of the pager
• Any modem commands needed for tasks such as timing, waiting for a dial
tone, accessing an external telephone line, and providing the pager Personal
Identification Number (PIN).
Example: 9,15555551234@
N
OTE: The modem supports only tone dialing, not pulse dialing.
Space
Character
The character (*, @, #, or None) that this pager requires to display a space
between the site ID and event code in the numeric message. Default:
*
End String One to ten characters appended to the dial string to ensure that the modem
hangs up after it pages the recipient. You need an end string only if the paging
service has a menu for reviewing and leaving messages.
Send Out-of-
Band
Management
Event Codes
Mark this box to enable automatic conversion of Network Management Card
event codes to default Out-of-Band Management Card event codes if your
network has both types of cards, and you want paging notifications to use the
same event codes regardless of which card reports the event.
Default: Disabled
N
OTE: By default, Out-of-Band Management Cards enable paging for some
events for which Network Management Cards do not. (By default, Network
Management Cards enable paging for severe events only.) To ensure that
paging is enabled for the same events throughout your system, enable or
disable paging for individual events through the user interface of either card.