User`s guide

®
USER’S GUIDE Network Management Card
106
Use the Wizard
Launch the Wizard
The installation creates a shortcut link in the Start menu to launch the Wizard.
Configure the basic TCP/IP settings remotely
Prepare to configure the settings. Before you run the Wizard:
1. Contact your network administrator to obtain valid TCP/IP settings.
2. If you are configuring multiple unconfigured Management Cards or network-
enabled devices, obtain the MAC address of each one to identify it when the
Wizard discovers it. (The Wizard displays the MAC address on the screen on
which you then enter the TCP/IP settings.)
• For a Management Card that you install, the MAC address is on a label on the
bottom of the card.
• For a network-enabled device (with an embedded Management Card), the MAC
address is on a label on the device.
• You can also obtain the MAC address from the Quality Assurance slip that came
with the Management Card or device.
Run the Wizard to perform the configuration. To discover and configure,
unconfigured Management Cards or network-enabled devices over the network:
1. From the Start menu, launch the Wizard. The Wizard detects the first
Management Card or network-enabled device that is not configured.
2. Select Remotely (over the network), and click Next >.
3. Enter the system IP, subnet mask, and default gateway for the Management
Card or device identified by the MAC address. Click Next >.
Most software firewalls must be temporarily disabled for the Wizard to
discover unconfigured Network Management Cards.