User`s guide

®
USER’S GUIDE Network Management Card
105
APC Device IP Configuration Wizard
Capabilities, Requirements, and Installation
How to use the Wizard to configure TCP/IP settings
The APC Device IP Configuration Wizard configures the IP address, subnet mask, and
default gateway of one or more Network Management Cards or APC network-enabled
devices (devices containing an embedded Management Card). You can use the Wizard
in either of the following ways:
• Remotely over your TCP/IP network to discover and configure unconfigured
Management Cards or devices on the same network segment as the computer
running the Wizard.
• Through a direct connection from a serial port of your computer to a Management
Card or device to configure or reconfigure it.
System requirements
The Wizard runs on Microsoft Windows 2000, Windows 2003, and Windows XP
operating systems.
Installation
To install the Wizard from the utility CD:
1. If autorun is enabled, the user interface of the CD starts when you insert the
CD. Otherwise, open the file contents.htm on the CD.
2. Click Device IP Configuration Wizard and follow the instructions.
To install the Wizard from a downloaded executable file:
1. Go to www.apc/tools/download.
2. Download the Device IP Configuration Wizard.
3. Run the executable file in the folder to which you downloaded it.