User`s guide

®
USER’S GUIDE
Network Management Card
103
Configuring Links (Administration>General>Quick Links)
Select the Administration tab, General on the top menu bar, and Quick Links on the
left navigation menu to view and change the URL links displayed at the bottom left of
each page of the interface.
By default, these links access the following Web pages:
• Link 1: The home page of the APC Web site.
• Link 2: A page where you can use samples of APC Web-enabled products.
• Link 3: The home page of the APC Remote Monitoring Service.
To reconfigure any of the following, click the link name in the Display column:
• Display: The short link name displayed on each interface page
• Name: A name that fully identifies the target or purpose of the link
• Address: Any URL — for example, the URL of another device or server
Reset Only
1
TCP/IP settings: Set TCP/IP Configuration to DHCP & BOOTP, its default
setting, requiring that the Management Card receive its TCP/IP settings from a
DHCP or BOOTP server. See TCP/IP settings (Administration>Network>TCP/IP).
Event configuration: Reset all changes to event configuration, by event and by
group, to their default settings.
UPS to defaults: Reset only UPS settings, not network settings, to their defaults.
Lost Environmental Communication Alarms: Clears any environmental alarms
caused by lost communication with a sensor, e.g., if a sensor is disconnected,
this setting returns the alarm status for that sensor to Normal.
Action Definition
1. Resetting may take up to a minute. The UPS name and output voltage settings will not be reset.