User`s guide

®
USER’S GUIDE
Network Management Card
102
Use an .ini File (Administration>General>User Config File)
Use the settings from one Management Card to configure another. Retrieve the
config.ini file from the configured Management Card, customize that file (e.g., to
change the IP address), and upload the customized file to the new Management Card.
The file name can be up to 64 characters, and must have the.ini suffix.
Instead of uploading the file to one Management Card, you can export the file to
multiple Management Cards by using an FTP or SCP script or a batch file and the APC
.ini file utility, available from www.apc.com/tools/download.
T emperature Units (Administration>General>Unit Preference)
Select the temperature scale (Fahrenheit or Celsius) in which to display all temperature
measurements in this user interface.
Reset the Interface (Administration>General>Reset/Reboot)
Status Reports the progress of the upload. The upload succeeds even if the file contains
errors, but a system event r reports the errors in the event log.
Upload
Browse to the customized file and upload it so that the current Management
Card
can use it to set its own configuration.
To retrieve and customize the file of a configured Management Card, see
How to Export Configuration Settings.
Action Definition
Reboot
Management
Interface
Restarts the interface of the Management Card.
Reset All
1
Check-mark Include TCP/IP to reset all configuration values; unmark Include
TCP/IP to reset all values except TCP/IP
1. Resetting may take up to a minute. The UPS name and output voltage settings will not be reset.