Specifications

NetShelter SX Cabinet - Installation and Customization Manual18
Remove the Cable Cutout Covers
For NetShelter SX 750 mm (29.5 in.) wide
cabinets that include equipment requiring
side airflow, on the side of the cabinet
nearest the air intake for the equipment
(right side in the example below), remove
the cable cutout covers from the front
vertical mounting flange. Reinstall the
covers in the cable cutout holes on the rear
vertical mounting flange on the same side of
the cabinet.
Cable Management
The NetShelter SX cabinet has multiple cable access openings, including on the roof, sides, and bottom. 
Route, secure, and organize cables using these openings.
In addition, two rear vertical 0U cable organizers, or accessory channels, are included with the cabinet. Further cable
management accessories are available. Please see www.apc.com, or contact a Schneider Electric 
re-seller for more information.
Accessory Channel
ns1923a
The accessory channels provide toolless mounting capabilities for Rack Power
Distribution Units and cable management accessories.
There are four Accessory Channels included with the 1200 mm (47.24 in.) deep
cabinet. There are two included with all other cabinets. The factory-default
position for the accessory channels is in the rear of the cabinet, as shown in the
graphic to the right.
The channels also provide tie-off locations for cables, as well as other specific
holes for managing cables with many NetShelter brackets, fasteners, and
toolless mounting equipment.
Similar to the mounting flanges, the accessory channel can be moved
anywhere along the side braces. See “Adjust the Vertical Mounting Flanges” on
page 14 for more instruction.

Note: If needed, the accessory channels can be removed. Additional vertical
0U accessory channels are available for order.
ns1071b

