Specifications

NetShelter SX Cabinet - Installation and Customization Manual12
Reverse the Front Door
Note: The front door can be reversed so that the door opens in the other direction. This procedure assumes that
initially, when facing the cabinet, the hinges are on the left and the door is opening from right.
1. Remove the handle by removing the screw-plate.
Pull the handle from the door.
2. Disconnect the ground wire, and any other wire
connections. Remove the door from the frame.
See “Door Removal” on page 11 for more
information.
3. Locate the upper hinge on the cabinet frame.
Remove the two screws holding the hinge in
place. Install the hinge onto the other side of the
cabinet frame. Repeat this step for the lower
hinge.
4. Rotate the door . Remove the hinges  from
the door, and install them to the alternate hole
location . The hinges on door should now align
with the hinges on the cabinet. 
5. Install the door to the hinges now on the reverse side
of the cabinet frame. See “Door Removal” on
page 11 for instruction. Connect the ground wire and
any other wire connections previously disconnected.
ns1752b
ns1758b
ns1824a
ns2289a


