Specifications

Rack Access PX-HID Installation 17
2. Use Ping with a size of 113 bytes to assign the
IP address defined by the ARP command. For
the IP address defined in step 1, use one of the
following Ping commands:
Windows command format:
ping 156.205.14.141 -l 113
LINUX command format:
ping 156.205.14.141 -s 113
3. Use Telnet to log on to the Rack Access
PX-HID at its newly assigned IP address. For
example:
telnet 156.205.14.141
4. Use apc for both User Name and Password.
See “Control console” on page 17 to finish the
configuration.
Control console
After you log on at the control console, as
described in “Local access to the control console”
on page 16 or “Remote access to the control
console” on page 16:
1. Choose Network from the Control Console
menu.
2. Choose TCP/IP
from the Network menu.
3. If you are not using a BOOTP or DHCP
server to configure the TCP/IP settings, select
the Boot Mode menu. Select Manual boot
mode. Set the System
IP, Subnet Mask, and
Default Gateway address values, and then
press
ENTER to return to the TCP/IP menu.
(Changes will take effect when you log out.)
4. Press
CTRL-C to exit to the Control Console
menu.
5. Log out (option 4 in the Control Console
menu).
If you disconnected a cable during
the procedure described in “Local
access to the control console” on
page 16, reconnect that cable and
restart the associated service.