Specifications

Rack Access PX-HID Installation 9
Installation—Accessories
Door switch
1. Choose a location at the top of the enclosure to
install the door switch and door switch
magnet.
Front door: Install the front door switch and
front door switch magnet perpendicular to the
floor.
Rear door: Install the rear door switch and
rear door switch magnet parallel to the floor.
2. Connect the door switches to the enclosure
frame.
a. Attach the part of the door switch with the
wire connectors to the door frame of the
enclosure, using two screws (provided).
b. Cut back the covers on the ends of both
wires on the RJ-45 door switch cable
(provided), and remove a small amount of
insulation from the end of each wire. Be
careful not to cut through the insulation into
the wire itself.
c. Place the bare ends of the wire under the
square metal washers and wrap them
clockwise around the screws. Tighten the
screws.
Doors with Rack Access PX-HID
locks must have door switches.
aem0080a
aem0181a
aem0060a