Camera Accessories User Manual

NetBotz Camera Pod 160 Installation Manual

Enclosure

Note: Use a #32 drill to make four 2.94-mm (0.116-in) pilot holes.

Connect Optional Devices

As applicable, install the options listed below, then connect them to the back of

the NetBotz 160.

• Door Switch Sensor for APC Racks (NBES0303) or Door Switch Sensor

for Rooms of Third-Party Racks (NBES0302)

• External microphone

• Set of speakers

Note: If the cable of a Door Switch Sensor for APC Racks is

not long enough, use an RJ-45 coupling provided with the

sensor to extend the cable up to 15 m (50 ft).